Cadillac CTS-V Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
328 Posts
would prob have to see it on a dyno to see if ur actually loosing torque or not, or could just be the resistance to knock affecting it as just going by knock only shows when u have gone too far on petrol or way too far on toluene or way way way too far on ethanol :unsure:
 

·
Registered
Joined
·
328 Posts
think i posted a while ago the maths u can put in the hpt chart v time that gives u a value of acceleration then u can actually see if ur gaining speed or not with the timing adjustments, if u didnt see it let me know ill put it in here
 

·
Registered
Joined
·
328 Posts
maths is ([8001.113.avg(-1500)]) - ([8001.113.avg(1500)]) u have to log ''undriven wheelspeed'' so ur using the front wheels so not wheel spin can affect it, use scale of say -40 to 40 so its basically the wheel speed against itself over time past and future so if its increasing in acceleration the number will go higher, if u want a different value output u can play with the time in each 1500 or -1500 if u change one change both the same but should be fine as is
 

·
Registered
Joined
·
328 Posts
Is this a filter or the set up for a graph
just put that equation in the maths, then use the user maths pid in the chart v time to see the value/trace
 

·
Registered
Joined
·
328 Posts
also just to note because the math uses future and past in the equation it wont work live, u will have to finish the log and then watch it to see it working right
 
1 - 5 of 5 Posts
Top