Cadillac CTS-V Forum banner
1 - 12 of 12 Posts

· Premium Member
Joined
·
4,480 Posts
Pretty sure there was one aftermarket that was made only for the coupe, not a sedan.
 

· Registered
Joined
·
2,315 Posts
v2 sedan carbon diffuser. I made this from a D3 fiberglass diffuser that needed alot of work to fit . this was my result. Good luck finding one but i think baldo performance in long beach may have the molds for both sedan and coupe

 
  • Like
Reactions: Blown376

· Registered
Joined
·
36 Posts
Discussion Starter · #6 ·
Looks great. Thanks for the reference.

I cannot find a baldo's performance.

I contacted baldos performance. They do have the rear diffuser mold. But he said it is not worth making a production run unless he got at least 5 orders. And he would not be able to until around july.
 

· Premium Member
Joined
·
16 Posts
I contacted baldos performance. They do have the rear diffuser mold. But he said it is not worth making a production run unless he got at least 5 orders. And he would not be able to until around july.
If they could do one to fit a CTS-V coupe, I'd order one.
 
  • Like
Reactions: mememe123

· Premium Member
Joined
·
3,046 Posts
He didn’t say what July, 22, 23 , 24, 25… I can go on! Haha
 
  • Like
Reactions: Blades1_99

· Registered
Joined
·
36 Posts
Discussion Starter · #10 ·
Spoke to Balto performance again today. He advised he had a couple inquiries about rear diffusers recently. He does have the D3 mold and he advised he will be focusing on the production closer to the end of this year or early next year. He said he may try to offer a group buy. All we can do is hope he follows thru.
 

· Registered
'14 Coupe
Joined
·
559 Posts
They have it on the site, but sold out.
I wonder how much trimming is required for stock muffler :unsure:

Edit:
And answered my own question by searching.

I think I'll pass.
 
1 - 12 of 12 Posts
Top