Cadillac CTS-V Forum banner
1 - 6 of 6 Posts

·
Registered
2012 CTSV coupe
Joined
·
415 Posts
Discussion Starter · #1 ·
Installing my ID1300's. Am I correct in assuming the factory injector retainer clips are not used on the fuel rail?
 

·
Registered
Joined
·
1,474 Posts
The clips fit fine.
 

·
Registered
2012 CTSV coupe
Joined
·
415 Posts
Discussion Starter · #3 ·
The diameter if the ID injector seemed to be too big causing the clip to be pushed out enough to not engage the lip of the fuel rail.

Sent from my SM-N975W using Tapatalk
 

·
Registered
Joined
·
3,270 Posts
I have 1300s..they fit but I am using the adapters that have their own clips....if that helps.
 

·
Registered
Joined
·
1,416 Posts
The diameter if the ID injector seemed to be too big causing the clip to be pushed out enough to not engage the lip of the fuel rail.

Sent from my SM-N975W using Tapatalk
Are you sure you have the Injector seated all the way into the rail? and once it's in, the clip should go right in the slot (which is clocked on the injector), you may have to rotate the clip to align with the slot. I'm referring to the ID 1300 that are same as OEM.
Good Luck
 

·
Registered
2012 CTSV coupe
Joined
·
415 Posts
Discussion Starter · #6 ·
Thanks for the quick responses. I wasn't getting the clip in the slot in the injector.
 
1 - 6 of 6 Posts
Top