Cadillac CTS-V Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
208 Posts
Discussion Starter · #1 · (Edited)
I got a little bored today with my company giving us Juneteenth off and I had no plans. Decided to starting polishing the front upper strut bar. Used my small orbital up to (220/400) grit and everything past that was wet sanding with (1000/3000).

Just finished buffing using my large orbital with Megiures ultra cut compound to get out the fine scratches from the 3000 grit sanding. I’ll have to come back to it later with a much gentler polish to finish it off. It’s been about two hours in all and my arms are silly putty.






Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
208 Posts
Discussion Starter · #13 ·
200/400 grit seems a bit rough, but clearly turned out great! I’d like to see the before pics myself. Are the V3 strut bars made of aluminum like V2’s, anyone know? Lucilles strut bar could use a little love itself.
I probably could have started with 400 but started lower after some initial sanding looked like it would have been harder to remove material. The grain in the raw aluminum is harder to sand down than you’d expect. Here is a pic from the underside of the bar that shows an un-sanded section, I didn’t really do anything underneath the bar since no one will see it.

Grey Wood Natural material Metal Office supplies

Grey Wood Composite material Natural material Blade
 
1 - 5 of 5 Posts
Top