Cadillac CTS-V Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
643 Posts
Discussion Starter · #1 ·
So I have a general question, I have received most of the parts for my mod starting point. What I’m installing

lingenfelter 2.55 pulley setup
Mamo ls7 tb
1050x injectors
Long tube headers.

I’m more then capable ofdoing the wrenching but I’m no tuner, not even going to go there.

my question, would I hurt anything if I were to install the parts to save on that labor and then tow the car or whatever to the tuner? Would that in anyway affect the tuning process as far as baseline or anything ( again I know nothing about tuning)!
 

·
Premium Member
Joined
·
1,307 Posts
That wouldn't hurt anything. The injectors will have to be tuned for it to run or at least for it to run well after installation so hauling it to the tuner afterwards will be fine.

If you had HP Tuners, you could scale the injectors yourself and drive it to the shop doing the tuning.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top