[SofaKingSlow]

Those of you with ZL1 lids AND engine cover: How did you route your hoses to fit under the lid?
My concern is limited to the direction of the hoses into and out of the lid, because there are threads upon threads dedicated to the debate of the "best" way to route HX hoses.
As it stands, my lid won't fit. I only hope it is the hoses alone that prevent the cover from seating properly.
Edit: 3/4 inch hoses and -12 fittings throughout.

 

[jrV]

Mine fits nicely... on a shelf in my garage lol. I'd have to do a lot of trimming because of the e-85 setup on the fuel rail. It's somewhere on my list of things to do. I need to reroute my hoses too. Seems routing the hoses around the drivers side is the best route requiring minimal trimming.

 

[SofaKingSlow]

I'm looking for one of these...

And when I get one, I'll post my results.

 

[kittyboy]

Mine fits nicely... on a shelf in my garage lol. I'd have to do a lot of trimming because of the e-85 setup on the fuel rail. It's somewhere on my list of things to do. I need to reroute my hoses too. Seems routing the hoses around the drivers side is the best route requiring minimal trimming.

Don't think the red decorative shroud cover will fit well? As far as routing the cooler lines, the flow of 'ice' should go directly to the brick.