Cadillac CTS-V Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
1,174 Posts
Discussion Starter #1
Anyone have an engine harness layout for 2010 V2 sedan they can share?
 

·
Registered
Joined
·
1,174 Posts
Discussion Starter #3
Auto or manual? What harness specifically? Are you looking for a pin out or how it runs?



Sent from my iPhone using Tapatalk
A6.

Looking for how the harness runs around the engine bay as well as trace back some other wiring that the PO had for the launch controller and nitrous setups.
 

·
Registered
Joined
·
39 Posts
Did you ever get a diagram? I'm looking for one as well.
A6.

Looking for how the harness runs around the engine bay as well as trace back some other wiring that the PO had for the launch controller and nitrous setups.
Sent from my SM-N950U using Tapatalk
 

·
Registered
Joined
·
2,988 Posts
Did you ever get a diagram? I'm looking for one as well.

Sent from my SM-N950U using Tapatalk
Anything specific you need help with?

I can provide detail on any aspect of the harness as my engine is out right now.
 

·
Registered
Joined
·
39 Posts
I'm putting my engine in and wanted to make sure I have all the connections correct. Also to make sure I put the bolts for the bellhousing that have the extra thread where they're supposed to be.

Sent from my SM-N950U using Tapatalk
 

·
Registered
Joined
·
2,988 Posts
It should be fairly well poke yoked if you remember the layout at all. Does a U around the engine and the DS loops back around under the motor mount for a few sensors. Tranny is down both sides, straight forward as well.
 

·
Registered
Joined
·
1,174 Posts
Discussion Starter #9
Did you ever get a diagram? I'm looking for one as well.

Sent from my SM-N950U using Tapatalk
I didn't.

I just stuck with it and eventually traced everything down.
 
  • Like
Reactions: steve

·
Registered
Joined
·
11 Posts
Looking for the harness layout myself if anyone can help. Putting my now fully forged lsa back in my 09 auto trans cts-v. I had taken many photos with my phone but phone died and photos lost. It has been several months since removal and my oldtimers memory sucks. Any help is appreciated.
 

·
Banned
Joined
·
28 Posts
Anyone have a link or file for wiring lay out? As well as where the longer threaded trans bolts go?
 
1 - 12 of 12 Posts
Top