Joined
·
207 Posts
I want to run my ethanol sensor wire through the right side fuel rail connector. The lone loose white wire used totally clashes with my "Dude, you need to clean your engine bay" theme I am going for under the hood.
I need to know what pin terminals to order.
Based on research and blind googling, I am only about 60% certain they are metripack 150 series. I am also not sure if the wires are used in the engine harness are 18ga or 20ga.
Any ideas?
As penance, I vow to attempt a write up detailing the process.
I need to know what pin terminals to order.
Based on research and blind googling, I am only about 60% certain they are metripack 150 series. I am also not sure if the wires are used in the engine harness are 18ga or 20ga.
Any ideas?
As penance, I vow to attempt a write up detailing the process.
