Cadillac CTS-V Forum banner

1 - 11 of 11 Posts

·
Banned
Joined
·
4 Posts
Discussion Starter #1 (Edited)
Can someone let me know the proper offset & backspace I need to run Weld s71?

Front: 18x9.5
Rear: 17x11

I've searched the forums for the past 7 hours and there isn't one actual answer to this question.. anywhere. even on the "Tired of the BS" thread.
 

·
Registered
Joined
·
1,551 Posts
For the "Facebook" like question of the day...

This question has been asked before.

Shame that there isn't a search function that works just fine.
 

·
Registered
Joined
·
1,178 Posts

·
Registered
Joined
·
640 Posts
MeanMike is spot on with his answer regarding the rear 17x11 being vette wheels. Weapon-X motorsports sells them and recommends using a spacer for clearance, though I’ve read post where some folks didn’t need them.

I’ve been looking at them as well because they’ll allow you to run a 335 Drag radial. Give them a call they’re a Weld distributor and can answer all your questions. Plus with the holidays being here you could save some money.
 
  • Like
Reactions: MYV

·
Super Moderator
Joined
·
20,840 Posts
For the "Facebook" like question of the day...

This question has been asked before.

Shame that there isn't a search function that works just fine.
He stated elsewhere that not all answers are available.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
108 Posts
Wondering if it would work
With a 10.5 +50 there is room in and out at stock height. I don’t think there would be an issue lowered within reason. With a 10 +43? The tire will push outward about 1/4” but I bet the 28x11.5 will clear. Remember its a bias tire too.


Sent from my iPhone using Tapatalk Pro
 
1 - 11 of 11 Posts
Top