[tramminc]

It's a ghost town as far as V's are concerned. I'm in the middle of FL. my car feels like a lonely step child.

 

[tinman]

We have a few just northeast of you in Jacksonville. Remember, Florida has a lot of Old Farts who move slowly. These cars are just too fast for them.

 

[Blades1_99]

It's a ghost town as far as V's are concerned. I'm in the middle of FL. my car feels like a lonely step child.

Where are you?

 

[tramminc]

Kissimmee area

 

[bettywhtV]

I'm over in St Cloud, just saw a silver V2 for the first time by me last week

 

[tramminc]

Might have been me.

 

[bettywhtV]

silver with cutouts?

 

[Blades1_99]

There are a few over on the East Coast/Orlando area. Cal Hartline is Melbourne. @AmandaRaeJeann goes up to Orlando Speedway too.

 

[AmandaRaeJeann]

I'm in the Brevard area near Cal. I do go to the speedway when I get the chance. Just finished putting the DSX on the V, hoping to get lower in the 10s. Fingers crossed! 😜

 

[bettywhtV]

There are a few over on the East Coast/Orlando area. Cal Hartline is Melbourne. @AmandaRaeJeann goes up to Orlando Speedway too.

Do you ever come over to Orlando Speedworld?

 

[bettywhtV]

I'm in the Brevard area near Cal. I do go to the speedway when I get the chance. Just finished putting the DSX on the V, hoping to get lower in the 10s. Fingers crossed! 😜

Been trying to decide between the DW pumps or the DSX aux kit. Just a little hesitant to drill the tank. How do you like the DSX kit?

What mods did you have when you ran your 10.9?

 

[SimplyDreamin]

Kissimmee area

I remember that area from back when I was in the Navy, back in ‘90. Nice area.


Sent from my iPhone using motherf’n Tapatalk!

 

[AmandaRaeJeann]

Literally just installed the DSX this week. It was scary drilling the tank. But as long as you have the proper nptf tap and the sealant required it should be all good. The DW I didn't want to cut the back part of under the seat or drop the tank to make your own access hole or whatever. They make an after market version for the access panel but you still gotta cut regardless. So I opted with the DSX since I already had it.

My V is a stock bottom end with exhaust, intake, and upper pulley. It is flex fuel, and has bigger injectors too. Small bmr ice box that doesn't do much. lol

 

[Blades1_99]

Do you ever come over to Orlando Speedworld?

For Cadillac Attack

 

[AmandaRaeJeann]

For Cadillac Attack

Yeah I'll be there!

 

[09SEETSV]

One would think here in Dallas that u would see em all over the place. But that is not the case... See em at some car shows every now and then, i have a few buddies who own em. Mine will be here next week.

 

[Blades1_99]

I'm in the Brevard area near Cal. I do go to the speedway when I get the chance. Just finished putting the DSX on the V, hoping to get lower in the 10s. Fingers crossed! 😜

Amanda, you should start a FB page that integrates with the FB group we're both in, and like the one I moderate for Tampa Bay.

I'm probably going to bring a couple of cars down for Homestead laps on the 31st.

 

[AmandaRaeJeann]

I've thought about it, but I am not even sure where I would start. lol Def something to consider doing though!

 

[Blades1_99]

I've thought about it, but I am not even sure where I would start. lol Def something to consider doing though!

It isn't hard.

 

[tramminc]

silver with cutouts?

Nope, was not me. I'm loud but not that loud.