[random84]

I have a few parts for sale on the cheap. Most will need odds and ends as stated:

Items sold.

3. A 10.5 lower pulley for Innovators West hub. Used but in great shape. $60 shipped

4. A Dsteck original (I bought it direct) Aux kit fuel pump controller and a flex fuel tube with fittings. The wiring harness and Aux controller are unmolested. You will need a new walbro / TI pump, either GSL 392 or the larger GSL 396 and you'll have to make fuel lines(!). I have most of the fittings included and can included some fuel line fittings to help if needed. But I hacked up the original lines when modding my fuel system, so these are "as-is" for an Aux kit on the cheap. I even have the tank drill and tap to include. $250 for everything.

You will need a flex sensor and fab fuel lines, but it will save you $800 off new!

5. High flow 3/4" Y fittings for an intercooler lid, machined from billet aluminum. NIB. $50 shipped.

6. A 102mm spacer, gaskets and bolts. Gasket is 3/8" thick.

Sent from my SM-G991U1 using Tapatalk

 

[Blown376]

How would you use the Y fittings? Curious minds want to know.

 

[random84]

How would you use the Y fittings? Curious minds want to know.

I was going to use them for my intercooler lines. Any of the bigger blowers with larger bricks or two bricks (2300, 2650, Maggies) have "dual" inlet/outlet setups, so these are more efficient and easier to route than using a T fitting for most applications. In my situation, they didn't work.

 

[random84]

DDP intake sold.

Sent from my SM-G991U1 using Tapatalk

 

[random84]

Open to offers on any of this stuff.

 

[random84]

Dynospeed intake sold elsewhere.