[Htwnstk]

18x5 Forgestar D5s with 28x4.5x18 Hoosier Bias Ply Runners and 17x10 Beadlock D5's with 28x10.5x17 Hoosier Drag Radial Slicks. Rears are perfect but i am getting some pretty heavy rubbing on the rear part of the front inner liners on both sides. Stock height. I'm considering just pulling the inner liners out, or do I just need to go down to a 26 front runner?

 

[Bpearl2010]

Looks great man! I was just looking at this same setup for my V3... Wish you were look in Florida so i could test fit them

 

[Rekkr]

I dig it. I also get a little rub on the front inner fender wells

 

[Htwnstk]

One thing I'm considering trying is going to a 215/55/r18 street tire which would be roughly 27.3" tall. I think that might be significantly better on the street and still much lighter of a combination on the track than my standard ctsv front wheels.

 

[Mystical]

You need a 26” front, 28” is way too tall. Looks good though, same wheels I’m running.

 

[Htwnstk]

Yeah same conclusion I came to. I might still try some 215/55r18s just to see if those are short enough to not rub, but if not I'll have to get the 26s.