Okay, so I am running a 400" highly modified motor with a 2650 Kong blower and enough pulley to generate 19+ psi at full beans. I run a typical catch can in the "valley/snout" loop as is traditionally done. My build is a 4-digit power level at the crankshaft, and I tend to push oil out of the...

Searched in this sub forum and no dice. Curious if there is a gaping hole in most dash kits if a single DIN is used, or if the radio is mounted in the upper portion of a double DIN opening with a pocket installed under it If anyone has an aftermarket single DIN set up I’d be interested and...

Finally got my banks guage and vent pod, this thing has tons of options and can even troubleshoot/diagnose. Haven’t gotten it installed yet but will post after it’s all set up

Hi all, 14 V with all basic bolt on mods, cam, etc. Did a short street pull and afterwards had what I think is steam coming out of the MM catch can. No milky oil, good oil pressure, nothing out of the exhaust. Intercooler brick seems solid as I pressure tested it. I guess a compression test is...